Handle Assembly - poolstar NETSPA CLEANER Guide D'utilisation

Note: There is a elastic thread which connecting the knob and body, DO NOT long-
distance pulling or pull at the knob , so as not to cause the thread snapped.
(2) Insert the plug of one end of charger, the indicator turns green.
(3) Insert the plug of another end of charger in the automatic cleaner,the indicator
turns red.
(4) Charge time is around 2.5-3 hours, and the indicator turns green when charging
finished.
(5) Plug out the charger from the automatic cleaner, then unplug the charger from
the power.
(6) Charger knob and the body have to be tighten up again,until it as picture B
shown, to make sure it won't be leakage.
Note: The rope need to be suck into the knob of charger by finger while tighten it
up.
(7) Now you can use the cleaner according to the instruction normally.
WarNiNG!
Charging must be done in indoors, in a well ventilated area away from the sunlight,
children, heat and ignition sources.
Never use the charger if any damage is found.
Use the original the charger provided only.
Make sure cleaner and the charger are clean and dry before set up.
cautioN! Put the charging cover after charging. Placing cleaner in water without
putting the charging cover will void your warranty.
Note: Charge the cleaner 3 hours prior to the first use. Normally cleaner can be
operated 45 to 60 minutes after fully charged.

4. Handle assembly

1. Install V-shape clip into connector as Picture A.
2. Insert the handle into the cleaner as B shown until the side
pin on the handle is secured in the Handle locking hole on the
cleaner.
A
3. To release the handle, press into the side pin and pull out
the handle.
B
18