poolstar NETSPA CLEANER Guide D'utilisation page 16

If the cleaner is not to be used for an extended period, detach it from the charger,
use dry cloth to clean and dry the cleaner and accessories. Store them in a well
ventilated area away from the sunlight, children, heat, ignition sources and pool
chemicals. Never leave the cleaner plugged for long term storage. Recharge the
cleaner every three months.
If you do not use the transparent body part, you should take it off the electric cleaner.
above warning and cautions are not intended to incorporate all possible
instances for risks and/or severe injury. Pool/spa owners should always exercise
intensive caution and common sense when operating the cleaner.
GettiNG started
1. suction head assembly
Notch up
Insert suction head into the body until two buttons
of body sides popping from holes of suction head.
Please keep the notch facing up.
Button
Hole
2. Battery assembly and replacement
(1) Push the button "a" forward along the arrow direction, until it not stuck the slot
of the connector.(as picture A shown)
(2) Holding the body while reversing the connector , and removing the battery
mounting from the body.(as "b" in picture B shown)
(3) Remove the used battery, and replace new NI-MH battery( or AA Alkaline battery
for P1112) according to the sign of positive & negative pole of the battery mounting.
( as shown in picture C )
(4) Install the battery mounting into the body(as picture D shown), pay attention the
positive & negative pole of the mounting(as picture "d" shown,)and the 2 springs (
as picture "d1" shown)alignment.
(5) Twist the connector into the body in clockwise, until the button "a" can buckle in
the slot of connector. As picture E shown.
(6) Now you can use the cleaner according to the instruction normally.
a
a b d d1
A B C D E
16