Philips 7000 Série Mode D'emploi page 21

Cleaning the pop-up trimmer
3 Rinse the hair chamber and shaving head
holder under the tap.
4 Remove the shaving heads. For detailed
instructions, see 'How do I replace the shaving
heads?.'
Note: Do not clean more than one cutter and
guard at a time, since they are all matching sets.
If you accidentally put a cutter in the wrong
shaving guard, it may take several weeks before
optimal shaving performance is restored.
5 Clean the cutter and guard under the tap.
6 Shake off excess water.
7 Put the shaving heads back into the shaving
unit. For detailed instructions, see 'How do I
replace the shaving heads?.'
8 Insert the hinge of the shaving head holder into
the slot in the top of the shaving unit and close
the shaving unit.
Clean the trimmer after each use to prevent
clogging and damage.
Never dry the trimmer teeth with a towel or
tissue, as this may damage the trimmer teeth.
1 Make sure that the appliance is switched off
and disconnected from the wall socket.
2 Push the trimmer release slide down to open
the pop-up trimmer.
23
English