Alesis DM10 MK II PRO Guide D'utilisation page 7

In a kit, each sound is called a "voice." You can change each voice and set some of its
parameters, letting you customize the collection of sounds in a kit.
To edit a voice:
1. Enter the Kit Edit menu (if you are not already viewing it).
2. Press the F1-Voice button to enter the Voice Edit menu.
3. Hit the pad whose voice you want to edit. The pad's name will appear at the top of the
display.
4. The display will show the pad's current voice and its parameters. On this page:
•
To select a parameter that you want to edit, use the Down and Up buttons:
Voice Number: The pad's current voice (001–758) and User Voices, up to 99).
o
Volume: The pad's volume (000–127).
o
Pitch: The pad's pitch offset in semitones (-08 to +08).
o
Pan: The pad's position in the stereo field (L8 to C to R8).
o
Decay: The amount of time it takes for the pad's sound to decay (-05–00). 00 is
o
the default and the longest amount of time. -05 is a very short time.
Reverb Level: The amount of reverb effect applied to the pad's sound (000–
o
127).
FX Level: The amount of effects applied to the pad's sound (000–127).
o
MIDI Note: When the drum module's USB MIDI port or MIDI Out is connected to
o
a computer or external MIDI device, the pad will send this MIDI note to it. If you are
not using those connections, this setting will not affect the trigger or its sound.
Kick Drum
Snare Drum (Center) 38
Snare Rim
Tom 1 (Center)
Tom 1 (Rim)
Tom 2 (Center)
Tom 2 (Rim)
Tom 3 (Center)
Pad Pattern: The song that starts when you hit the pad. The song will stop when
o
you hit it again.
Min Velocity: The minimum velocity needed to trigger the pad's sound.
o
Strainer: The tightness of the snare wires on the snare drum (Off, Loose, Low,
o
Medium, or Tight).
Note: Not all instruments have a snare strainer effect.
Muffling: The muffling effect of the snare, toms, and kick only (Off, 1 to 4).
o
Head Tuning: The tuning of the pad's head (-63 to +63).
o
Size: The size of the cymbal (-63 to +63). This setting only applies to cymbals.
o
Sustain: The amount of sustain of the cymbal (-63 to +63). This setting only
o
applies to cymbals.
•
To edit the parameter's setting or value, use the dial.
5. When you are done editing, you must save the kit before exiting the Kit Edit menu. See
below to learn how to do this.
36 Tom 3 (Rim)
Tom 4 (Center)
40 Tom 4 (Rim)
48 Ride Bow
50 Ride Edge
45 Ride Bell
47 Crash 1
43 Crash 1 (Edge)
58 Crash 2
41 Crash 2 (Edge)
39 Hi-Hat Open
51 Hi-Hat Open (Edge)
59 Hi-Hat Closed
53 Hi-Hat Closed (Edge) 22
49 Hi-Hat Pedal
55 Hi-Hat Splash
57
52
46
26
42
44
21
7