Alesis DM10 MK II PRO Guide D'utilisation page 5

Setup
Items not listed in Introduction > Box Contents
Monitors
Power
Getting Started
1. Make sure all devices are off and all volume knobs are set to "zero."
2. Connect the cable snake to the port on the bottom of the DM10 MKII Pro module (using
the two screws to secure it), and then connect the 1/4" ends of the cables to their
respective pads.
3. Connect any input sources (CD player, smartphone, etc.) to the Aux input on the DM10
MKII Pro.
4. Connect output devices (amplifier, mixer, etc.) to the Outputs on the DM10 MKII Pro.
5. Plug all devices into power sources, and turn on devices in proper order:
•
When starting a session, turn on (1) input sources, (2) DM10 MKII Pro, (3) output
devices.
•
When ending a session, turn off (1) output devices, (2) DM10 MKII Pro, (3) input
sources.
6. Use the Down and Up buttons to select a kit, and use the dial to adjust the volume of the
kit.
7. Hit the pads and slowly adjust the master volume and/or phones volume until an
appropriate level is reached.
8. When finished, be sure to set all volume knobs back to "zero" before powering off DM10
MKII Pro.
Note: DM10 MKII Pro will automatically power off if no activity is detected for 30 minutes.
You can enable or disable this function in the
are sold separately.
External MIDI Device
Cable Snake to
Drum Pads
Utility page.
Computer
Headphones
5