Sony WEGA KE-42MR1 Mode D'emploi page 32

Screen Size/Shift The "Screen Size/Shift" option allows you to adjust the size and
• Screen Size/Shift cannot be adjusted for a HD signal connected to the Y, P
C
B
• H Shift (Horizontal Shift) can only be adjusted for an RGB input signal
connected to the Scart Connector
• When "Screen Format" is set to "4:3" or "Wide," V Size (Vertical Size) and V
Shift (Vertical Shift) cannot be adjusted for the video input signal from
connected equipment.
Adjust Pixel
Adjust Pixel is only available for an RGB input signal connected to the PC
connector.
32
Menu System
position of the picture for each screen format.
To do this:
1 After selecting the option, press
2 Press
/
V Size (Vertical Size):
Press
Press
Screen Shift
H Shift (Horizontal Shift):
Press
Press
V Shift (Vertical Shift):
Press
Press
Reset:
Select OK to reset to the factory settings.
, P /C jacks of 5 and the "Memory Stick" input.
R R
The "Adjust Pixel" option allows you to adjust the picture from
RGB equipment.
To do this:
1 After selecting the option, press
2 Press
Auto Adjust:
Select OK to automatically make the best picture for the
input signal. Note that it may not be adjusted perfectly
depending on the input signal condition or picture pattern.
In this case, perform Auto Adjust again.
Dot phase:
Adjust between 00-100 when part of a displayed text or
image is not clear.
Total H Pixel (Total Horizontal Pixel):
Adjust when the general picture is not completely clear.
Reset:
Reset to the factory settings.
or to select the option and press
/ or to adjust the size and position of the picture.
to enlarge the Screen Size vertically.
to shrink the Screen Size vertically.
to move the screen to the left.
to move the screen to the right.
to move the screen up.
to move the screen down.
1/
or to select the following option.
.
. Then Press
, 2/ or 4/
.
/
B
.