Sony WEGA KE-42MR1 Mode D'emploi page 11

Mains lead and display
cable
If you damage the mains
lead or display cable, it may
result in fire or electric
shock.
• Do not pinch, bend, or
twist the cable
excessively. The core
lines may be bared or
cut, causing a short -
circuit which may in fire
or electric shock.
• Do not convert or damage the mains lead or
display cable.
• Do not put anything heavy on the mains lead or
display cable. Do not pull the mains lead or
display cable.
• Keep the mains lead or display cable away from
heat sources.
• Be sure to grasp the plug when disconnecting the
mains lead.
Refer to the operating instructions when
disconnecting the display cable. If the mains lead or
display cable is damaged, stop using it and ask your
dealer or Sony service centre to exchange it.
When not in use
For environmental
and safety reasons,
it is recommended
that the set is
switched off when
not in use - not left
in standby mode. Disconnect from the mains.
Cable wiring
Take care not to catch your feet on the cables. It
may damage the unit.
Installation
Do not install optional components too close to
the display unit. Keep optional components at
least 30 cm away from the display unit. If a
VCR is installed in front or at the right side of
the display unit, the picture may distort.
Heat
Do not touch the surface of the display unit. It
remains hot, even after the display unit has
been turned off for some time.
(continued)
11
Safety Information
GB