Quick Menu - Onkyo TX-L50 Manuel D'installation

> Before Start > Part Names

Quick Menu

1
50
> Install > Initial Setup
By pressing the Q button on the remote controller during
play, you can adjust frequently used settings, such as the
sound quality, using on-screen menus.
1. Press Q on the remote controller.
2. After the Quick Menu is displayed, select the content with
/ on the remote controller and press ENTER to
confirm your selection.
Quick Menu
Tone Bass
Level Treble
AccuEQ
Other
0 Change the initial values for each of the settings with the
cursors / .
0 To return to the previous screen, press
3. To exit the settings, press Q.
■ Tone
Bass: Enhance or moderate the bass range of the front
speakers.
Treble: Enhance or moderate the treble range of the front
speakers.
0 It cannot be set if the listening mode is Direct.
■ Level
Center: Adjust the speaker level of the center speaker
while listening to some sound.
Subwoofer: Adjust the speaker level of the subwoofer
while listening to some sound.
0 The adjustment you made will be reset to the previous
status when you turn the unit to standby mode.
> Playback
Supplementary Information | Advanced Setup | Others
■ AccuEQ
AccuEQ Room Calibration: Enable or disable the
equalizer function that corrects for distortion caused by the
acoustic environment of the room. If this is to be enabled,
then normally you should select "On (All Channels)", and to
disable just the front speakers you should select "On
(Except Front Left / Right)". The setting can be separately
set to each input selector.
BD/DVD
Equalizer: Select "Preset 1" to "Preset 3" configured in "2.
Speaker" - "Equalizer Settings" (
The same sound field setting is applied all ranges when set
to "Off".
Cinema Filter: Adjust the soundtrack that was processed to
enhance its high pitch range, in order to make it suitable for
.
home theater. This function can be used in the following
listening modes: Dolby Digital, Dolby Digital Plus, Dolby PL
II Movie, Dolby Surround, Dolby TrueHD, Multichannel,
DTS, DTS 96/24, DTS-HD High Resolution Audio, DTS-HD
Master Audio, DTS Neural:X, DTS Express, Neo:6 Cinema,
and DSD.
0 It cannot be set if the listening mode is Direct.
■ Other
A/V Sync: If the video is behind the audio, you can delay
the audio to offset the gap. Different settings can be set for
each input selector.
0 It cannot be set if the listening mode is Direct.
Music Optimizer: Improve the quality of the compressed
audio. Playback sound of lossy compressed files such as
MP3 will be improved. The setting can be separately set to
each input selector. The setting is effective in the signals of
48 kHz or less. The setting is not effective in the bitstream
signals.
0 It cannot be set if the listening mode is Direct.
Late Night: Make small sounds easily heard. It is useful
E
N
P58) in the Setup menu.