Samsung DVE G 50A8800 Série Mode D'emploi page 36

Installation
36 English
Untitled-2 36
10. Insert the screw you just removed into the other
screw hole on the back of the door hinge, and then
tighten.
11. Place the door on the other side, and then reattach it
to the dryer.
NOTE
Insert the head of the screw on the back of the hinge
into the hole above the cut out in the frame, and then
slide the door hinge down until it stops. Make sure the
protrusion on the back of the hinge is pressed into the
cut out before you tighten the hinge screws.
12. Push the lever holder into the cut out on the other
side of the door opening. Insert screws, and then
tighten as shown.
13. Re-attach the remaining screws to the remaining
holes above and below the lever holder, and then
tighten.
2021-05-25 3:49:23