Technical Specifications - Lanaform Lumi Lamp Manuel D'instructions

TECHNICAL SPECIFICATIONS

Power
Light element
Fuse
Light intensity
Operating temperature
Storage and transport temperature
Power supply
Product classification
Maximum output of radiation/ spectral radiant:
Location of emission aperture
Dimensions
Weight
This device has been developed and manufactured in compliance with the highest safety and performance standards, including electromagnetic
compatibility standards (EMC). This device also complies with the requirements of the directive concerning medical devices 93/42/EC
FAQ
Troubleshooting
No light
One side of the product is no longer working
The light continues to flash for 20 seconds after it has
been switched on
7
Normal conditions of use
24W
24W, E27 tubes, lifespan: 8,000 hours
T3.15AH250V
10,000 Lux at 10cm
10 to 35°C (moisture content: 30<H<90%)
Atmospheric pressure: 700-1060hPa
-20°C ~50°C (moisture content: <90%)
Atmospheric pressure: 700-1060hPa
220-240V, 50Hz
Class II equipment
No applied part
Not category AP / APG equipment
Mode of operation: Continuous operation.
1.8W.cm-2sr-1
Lamp Screen
200x85x240mm
0.5kg net
Possible causes
No current
Main power switch is turned off
Faulty tube
Tube at the end of its service life
Tube inserted incorrectly
Solutions
The device may not be connected properly or your
electricity supply is faulty
Switch on main power switch
Change the tube
Change the tube
Replace the tube
Version 01 Lot001 - 24/06/2015
EN