Varma Tec ECOWRN/7 Mode D'emploi page 11

ENGLISH
disconnect it from the power supply.
➢ Should the appliance be dropped or suffer a heavy blow, have it
checked immediately by Star Progetti.
➢ When carrying out maintenance operations, never touch the bulbs
directly, but only the terminal casings. The bulb will be damaged by
contact with naked hands; in this eventuality the product guarantee
will no longer be considered valid.
➢ In the event of accidental contact with the surface of the bulb, clean
it immediately by wiping with a cloth dipped in denatured alcohol.
➢ If the appliance does not function correctly or develops a fault, turn
it off and contact Star Progetti immediately.
➢ Ensure that only genuine original Star Progetti spares are used for
any repairs. If the cable or the power plug are damaged, take the
appliance to an authorised Star Progetti service centre for
replacement. Use a cable with T180 characteristics.
➢ Switch off the appliance at the main switch: a) if the appliance does
not function correctly; b) before cleaning the outside of the appliance;
c) if the appliance is not to be used for long periods of time.
➢ Do not cover or block the appliance during use.
➢ In order to avoid creating a fire hazard, the appliance must never be
installed with the radiating elements close to or facing towards
curtains, beds or other objects or materials that are liable to burn
easily; always ensure that these objects are at a suitable minimum
distance, to avoid any risk of fire or heat damage.
➢ Never use the appliance in combination with programming devices,
timers or other devices that will switch it on and off automatically.
➢ When the connection is made directly to the main electric net:
- You need to provide a device to ensure the all-pole disconnection
from the electric net with a opening distance from the
contacts, allowing a complete disconnection in the conditions of
overvoltage category III, in accordance with the installation
instructions.
1. TECHNICAL DATAS
Power: 1300 Watt
IP54 Infrared Heater protected against dust and water sprays.
220-240V 50/60 Hz Class I
2. EQUIPMENT
Appliances ECOWRN/7 are supplied complete with:
➢ Die-cast body in aluminium alloy, kiln varnishing with epoxy powders.
➢ Reflecting parabola made of polished ultra pure aluminium, anodically oxidised.
➢ Thermo resistant safety temperate anterior glass.
➢ Wall connection
➢ Silicone rubber seal gasket.
➢ Nylon-glass wiring box complete with PG11 cable clamp and terminal.
11