Bose Professional II Série Mode D'emploi page 10

Installation
Surface-mount Satellites
1. Loosen the screw connecting the loudspeaker arm to the wall-mount bracket, and separate the two parts.
2. Separate the rear plate from the cover the wall-mount bracket.
3. Use the template to mark the center of all four screw holes on the wall.
4. Insert four M4 (#10) screws to attach the wall-mount bracket plate to the wall. Make sure the point where the loudspeaker wire exits
the wall is aligned with a notch of the plate.
5. Reattach the wall-mount bracket cover to the plate, threading the loudspeaker wire through the center hole of the wall-mount bracket
cover.
Connect the wire to the loudspeaker. For wiring information, see Wiring the Loudspeaker (Page 6).
6.
7. Use the included screw to attach the loudspeaker arm to the threaded insert on the rear panel of the loudspeaker.
8. Place the loudspeaker arm on the wall-mount bracket by aligning the two parts of the rotating joint (which you separated in Step 1).
9. Adjust the vertical and horizontal angles of the loudspeaker as desired.
10. Insert the screw (which you removed in Step 1) into the rotating joint. Tighten the screw to secure the loudspeaker to the wall-mount
bracket at the desired angle.
q
r
y
i
10 • English
t
M4 (#10)
× 4
o
w
u
a
FreeSpace 3 Loudspeaker System • Installation Guide
PRO.BOSE.COM
e