Installation On The Helmet - N-Com B601 R Serie Mode D'emploi

EN
3

INSTALLATION ON THE HELMET

Important: Prior to installing the N-Com system, it is recommended to write down the identification code
affixed to the product (see chapter 16.3).
You can download the installation video from www.n-com.it N-Com / Download section.
•
Before you install the B601 system on the helmet, make sure it turns on properly. Press the "n" key for
about 2 seconds, until the blue LED on the key pad lights up and you hear a beep in the headset. Proceed
with the installation.
•
Remove the cheek padding (see helmet instructions).
•
Remove the helmet edge gasket using the special tool (Fig. 1).
•
Completely remove the gasket as shown in Fig. 1; by doing so you also remove the padding.
•
Remove the "N-Com" plugs found at the back of the shell gasket and on the left side of the helmet.
Fig. 1
•
Prior to installing the N-Com system, remove any filling foam material, if present, from the helmet (refer
to the user manual for your specific helmet).
Option 1
N.B.: Keep the filling material in case you wish to use the helmet without the N-Com system in the future.
8
Fig. 1 – ONLY FOR N87 – N100-5 HELMET
Option 2