Sharp KH-6I19FT00-EU Guide D'utilisation page 20

2L+2N 230V~
For the induction hob, the cable must
be H05VV-F 5X2,5 mm² 60227 IEC 53
••. You will find the connection diagram
shown on the bottom of your appliance.
400V 3N~
EN
ERROR CODES
If there is an error, error code will be
showed at heater displays.
E1 : The cooling Fan is disabled, call
an authorized service agent.
E3 : The power supply voltage is over
the rated values, turn the hob off by
touching ,wait until "H" disappears
for all zones, turn the hob on by pres-
sing and continue
to use. If same error appears, call an
authorized service agent.
E4 : Supply frequency is different from
the rated values, turn the hob off by
touching , wait until "H" disappe-
ars for all zones, turn the hob on by
pressing and continue to use. If
same error appears, plug off/on turn
the hob on by pressing
to use it. If the same error appears, call
an authorized service agent.
E5 : The hob inside temperature is too
high, turn the hob off by pressing
to let the heaters cool down.
E6 : Communication error between
touch control and heater, call an aut-
horized
service agent.
E7 : The coil temperature sensor is
disabled, call an authorized service
agent.
E8: The cooler temperature sensor is
disabled, call an authorized service
agent.
E9 : Calibration error, call an authori-
zed service agent.
continue