Getting Started; Connect To The Network - DNT IPdio Tune Mode D'emploi

Setup
Please follow those steps for connecting your radio to your network
Turn on the radio:
Plug the cable from the AC adaptor into the socket on the back of the radio, then switch on at the mains.
Use only the AC adaptor that supplied with the radio. Connecting a power supply with a dif-
ferent rating will cause permanent damage to the radio and may be hazardous.
Connect to network:
If you make a mistake at any point, press the BACK button to go back to the previous
screen.
The display on the front of the radio will light up and say:
Followed by:
If you listen to the Internet radio and Media player before you turned off the
radio, it will be automatically switched to Internet radio mode; Or if you was
listening to FM radio, it will be automatically switched to FM radio mode.
After a few seconds, this will change to show:
At first, you need to select network;
Press the SELECT button.
Rotate the dial until the display shows Configure.
Press the SELECT button.
Rotate the dial until the display says Network Config
Press the SELECT button.
Rotate the dial until the display says Wired/Wireless
Press the SELECT button.
Rotate the dial until your appropriate equipment; there is Auto, Wired Only,
Wireless Only Options.
If you select Auto, it will be select automatically.
If you select Wired Only, It will be only used for Wired Ethernet.
You should make sure the Wired Ethernet end has been plugged into the
RJ45 socket .
- 33 -

Getting started