Alarm Operation - auna Wallie Mode D'emploi

EN
44

ALARM OPERATION

Setting the alarm clock
This function allows the system to turn on automatically and wake you
using a beeping alarm, a CD, USB, BUZZER or RADIO.
1. In standby mode, hold the AL SET button (12) on the main unit for three
seconds, then alarm time "00:00" will appear on the display. Hour digits
of the alarm clock will start flashing.

2. Press the FORWARD or
and then press the AL SET button (12) again to confirm. Minute digits
will be flashing.

3. Press the FORWARD or
minute and then press the AL SET button (12) again to confirm. Alarm
wake up source will appear in display.

4. Press the FORWARD or
to CD, USB, Buzzer or radio, and then press the AL SET button (12) again
to confirm. Alarm volume level will be flashing.
NOTE: Alarm volume level setting is not available in beeping alarm
setting.

5. Press the FORWARD or
wake up alarm volume level and then press the AL SET button (12) to
finish alarm setup.
Notes on the alarm function:
1 If "Wake to CD,USB" is selected but a CD or USB is not inserted, the
alarm will default to the Beeping Alarm automatically when the alarm
wake time is reached.
2 For 'Wake to Radio," the system will default to the last radio station
listened to before switching off.
3 The volume of the alarm will be increased to the setting volume.
Active/deactivate alarm function
1. To activate ALARM, tap the AL SET button (12) once. The alarm icon
will be shown on LCD display.
2. To cancel alarm function, tap the AL SET button (12) again until the
alarm icon goes off.

BACKWARD buttons (3/1) to set the hour

BACKWARD buttons (3/1) to set the

BACKWARD buttons (3/1) to select wake

BACKWARD buttons (3/1) to preset the