Tv Display; Tv Type; Video Output - Teac DV-20D Manuel Du Propriétaire

A
VIDEO AUDIO SPEAKER

TV Display

TV Type

Video Output

Picture Mode
Slide show Mode
Angle Mark
Captions
Set TV Display Mode
B
VIDEO AUDIO SPEAKER
TV Display
TV Type
Video Output
Picture Mode
Slide show Mode
Angle Mark
Captions
Set TV Standard
C
VIDEO AUDIO SPEAKER
TV Display
TV Type
Video Output
Picture Mode
Slide show Mode
Angle Mark
Captions
Set Video Output
66
DISC SYSTEM
4:3 LB
PAL
RGB
Auto
None
On
Off
DISC SYSTEM
4:3 LB
PAL
RGB
Auto
None
On
Off
DISC SYSTEM
4:3 LB
PAL
RGB
Auto
None
On
Off
Settings 2
A
TV Display
Select the aspect ratio to match your TV.
4:3 LB (Letterbox mode)
When you connect a normal TV to the system, this setting
displays a wide picture with bands displayed on the upper
and lower portions of the screen.
16:9 Wide (Wide-screen mode)
Use this setting when you connect a wide-screen TV to the
system.
4:3 PS (Pan & Scan mode)
When you connect a normal TV to the system, this setting
displays a wide picture on the whole TV screen with a
portion (right and left sides of the picture) automatically cut
off.
< Some wide-screen discs that do not permit Pan & Scan
mode playback are automatically played in Letterbox mode.
< Depending on the DVD, 4:3 Letterbox may be selected
automatically instead of 4:3 Pan & Scan and vice versa.
< You must also set the screen mode on your wide-screen TV
to "FULL".
< If 16:9 Wide is selected and a normal TV is connected, 16:9
content will appear distorted during playback (objects look
thin).
B
TV Type
PAL:
Select PAL when a PAL TV (European standard) is
connected.
Multi:
Select Multi When a Multi TV is connected.
NTSC:
Select NTSC When a NTSC TV (American standard) is
connected.
C
Video Output
RGB (default):
Select this when your TV or monitor is compatible with RGB.
An RGB video signal is output from the AV CONNECTOR.
Component:
Select this when your TV or monitor is connected via the
COMPONENT VIDEO jacks.
A component video signal is output from the COMPONENT
VIDEO OUT jacks.
< Regardless of the setting, the VIDEO OUT jack is always
active.
< If you select an improper setting, no picture will be shown
on the screen. In this case, connect your TV via the VIDEO
jack or AV CONNECTOR to display the Setup menu, and
select the proper video output setting.
ENGLISH