Toparc BT-21452001-20 Manuel D'utilisation page 16

Translation of the original instructions
1. Firstly untighten and remove the compound holder.
Front Cap
2. Loosen M8 Screw (Fig.9) then remove the pushing block and plastic plunger disk (Fig10).
3. Screw back on the compound holder then remove the front cap.
4. Use a sharp knife to cut the tip of caulking tube at least 3 mm in diameter.
This will allow the tool to provide a optima seam width for most of applications.
16
CORDLESS CAULKING GUN / GLUE GUN
Compound Holder
Pushing Block
Fig.8
Fig.9
Fig.10
Fig.11
EN