Tool Operation - Toparc BT-21452001-20 Manuel D'utilisation

Translation of the original instructions
1. Charger is plugged into a 100-240V a.c outlet only.
2. If the battery pack is too hot or too cold, the charger will not fast charge the battery pack and the red Indi-
cator light is "blinking". When the battery pack temperature returns to between 0°C(32°F) and 50°C(122°F),
The charger will automatically begin charging.
3. If both red and green indicator lights are "ON" the battery pack either does not comply or is defective. Please
contact your retailer.
4. Do not charge the battery pack in the rain, snow or high temperature environment.
5. Do not charge battery pack when environment temperature is below 0°C(32°C)or above 40°C(104°C)
6. While charge the cool battery pack (below 0°C) in the warm indoor, keep the battery pack in the room for
one hour to warm up before starting the battery pack.
7. Remove the plug after finishing the charge.
8. The charger should be cooled at least one hour after continue charging three times.
9. Do not use generator for charging the battery pack.

TOOL OPERATION

For Sausage Bag Application
1. Cut a hole in one end of the sausage bag
as shown in the figure below.
Approx. 2 cm across
3. Insert the sausage bag into the compound holder. Screw the front cap on tight. It is not ne-
cessary to pull back the rack by hand. Make sure the sausage bag is insert properly and sit up
right on the plastic plunger disk.
4. Push the Rear Knob forward gently to force the rack tighten with the sausage bag.
For Cartridge Application
CORDLESS CAULKING GUN / GLUE GUN
WARNING
plunger disk
Plastic Plunger Disk
Fig.4
Fig.5
Fig.7
2. Remove the front cap. Fit the nozzle inside
the front cap and cut off the tip at a point
suitable for the job.
Fig.6
EN
15