Toparc BT-21452001-20 Manuel D'utilisation page 14

Translation of the original instructions
OPERATING INSTRUCTIONS (SLIDE-IN)
Installing or Removing Battery Pack
1. Always switch off the machine before insertion or removal of the battery pack.
2. To remove the battery pack, push the button on the battery pack and pull the tool unit
from the battery pack in the direction.
3. To insert the battery pack, align the tool unit slides with the battery pack sliding groove
and push the tool unit into place.
4. The tool unit can be slide into battery pack in two directions.
5. Do not force the battery pack in sliding it into tool unit. If the battery pack does not slide
in easily, it is not being inserted correctly.
Charging the Battery Pack
1. Connect the plug to the charger before charging.
2. Plug the fast charger into the power source.
3. Slide the battery pack into the charger as the arrow direction shown on the charger.
4. Push the battery pack into place and make sure the red light on the charger is "ON".
The battery pack is now starting the charging cycle.
5. After finish the charging cycle, the light will turn into green. The battery pack is now
ready for use.
6. Your new battery pack is not charged. You need to charge it before use.
7. If you try to charge a battery pack from a just-operated machine, sometimes the
charging light will not come on. If this occurs, let the battery pack cool for a while then
re-insert it and try to charge again.
8. When you charge a new battery pack or a battery pack which has not been used
for a long period, it may not accept a full charge. This is a normal condition and does
not indicate a problem. You can recharge the battery pack fully after discharging it
completely a couple of times.
9. Unplug the charger from the power source after finish the charge.
10. Please remove the battery from the unplugged charger for storage.
Battery Pack LED Indication Function(Optional)
The Battery Pack has a "SW" button and 4-step green LEDs for indicating remaining capacity status. The fuel gauge
green LED will indicate when the "SW" button is momentarily pressed.
Remaining Capacity LED Indication
LED 1 (green)
LED 1, 2 (green)
LED 1, 2, 3 (green)
LED 1, 2, 3, 4 (green)
14
CORDLESS CAULKING GUN / GLUE GUN
RC Status
0%- 25%
26%-50%
51%-75%
76%-100%
EN