Peavey Headliner 1000 Mode D'emploi page 7

Tour Series Headliner Head
NOTE: All specifications tested with
mains voltage maintained at nominal
level.
Line Voltage:
120V 60 Hz
220V - 240V 50/60 Hz
Typical Power Consumption = 200W
Power Amplifier Specifications:
Protection:
DDT speaker protection with defeat
™
switch
Short circuit protection
Thermal protection circuit
Current limit protection circuit
DC output protection circuit
Input Sensitivity (signal into return
jack with master volume set to 5):
7.32 dBu
Power Output:
All measurements with no more than
1% THD + N
All specifications tested with mains voltage maintained at nominal level.
Tour Series Headliner
™
8 ohms 700 watts (75.0 VRMS)
4 ohms 1000 watts (63.2 VRMS)
Headphone Amplifier Specifications:
Stereo 8 ohm minimum load
Power Output:
All measurements with no more than
1% THD + N
8 ohms 250 mW (1.41 VRMS) x 2
Preamplifier Specifications:
Settings for the Following
Measurements (unless stated
otherwise):
PRE GAIN = 5 (12 o' c lock)
BRIGHT = out
CONTOUR = out
CRUNCH = out
LOW = 0 (12 o' c lock)
HIGH = 0 (12 o'clock)
GRAPHIC EQ = All sliders set to center
GRAPHIC EQ SWITCH = out
COMPRESSION = OUT
POST GAIN = 10 (fully CW)
DDT = Active
™
Input Sensitivity (input selector set to
passive):
Nominal Input = -17.8 dBu
Minimum Input = -40.9 dBu
Features and specifications subject to change without notice.
Head Specifications
™
Maximum Input = 1.3 dBu (maximum
signal at input before clipping)
Input Sensitivity (input selector set to
active):
Nominal Input = -3.80 dBu
Minimum Input = -31.3 dBu
Maximum Input = 10.2 dBu (maximum
signal at input before clipping)
D.I. XLR Output:
Balanced output driven pre-EQ by
buffered instrument signal Foot
Switch Jack:
Ground switching type, TRS phone
plug (T = compressor, R = crunch, S =
ground)
Weight:
12 lbs. / 5.4 Kg
Dimensions (h x w x d):
(h x w x d): 2.813in / 7.14cm x
17.375in / 44.13cm x 12.500in
7