Technical Data - Einhell Royal REL 2450E Mode D'emploi

Anleitung_REL_2150_2450E_SPK1:_
well-lit conditions.
N
Do not underestimate the forces involved. Make
sure you stand squarely and keep your balance
at all times.
N
If possible, avoid using the tool on wet grass.
N
Ensure that you maintain a steady foothold
particularly while working on slopes.
N
Always walk. Never run.
N
Always keep the ventilation opening clean.
N
Never direct the vacuum/blow hole at persons
or animals.
N
The machine may only be used at reasonable
times of the day, i.e. not in the early morning or
late evening when it will be a nuisance to other
people. Permitted times of use specified by local
authorities must be observed.
N
The machine must be run at the lowest possible
motor speed required to carry out the work.
N
Remove all foreign objects with a rake and
brush before starting any blowing work.
N
Where conditions are dusty, dampen the
surface a little or use a sprinkler attachment.
N
Use the full-length blower nozzle extension so
that the air current can work near to the ground.
N
Watch out for children, pets, open windows etc.
and blow the foreign objects safely away from
them.
Maintenance and storage
N
Check that all nuts, bolts and screws are
securely tightened in order to be sure that the
machine is in a safe working condition.
N
Frequently check the grass catching devices for
signs of wear and deformation.
N
Only use replacement cutters of the correct
type.
N
For your own safety, replace worn or damaged
parts without delay.
N
Electric tools should be kept in a dry place when
not in use.
The tool can be plugged into any socket-outlet (with
230 V AC) that is equipped with a 10A fuse or higher.
The socket-outlet has to be safeguarded by an earth-
leakage circuit breaker (e.l.c.b.). The operating
current must not exceed 30 mA.
Safety pictograms on the tool (Fig. 8)
1. Read the directions for use before operating the
tool.
2. Do not use the tool in rain or snow. Do not ex-
pose the tool to wet conditions.
3. Keep all other persons away from the danger
zone.
28.12.2006 14:42 Uhr
4. Wear goggles and ear muffs.
5. Switch off the tool and pull out the power plug be-
fore carrying out any cleaning or maintenance
work.

4.0 Technical data

AC motor 230V ~ / 50 Hz
Output REL 2150 2150 watts
REL 2450E 2450 watts
no load speed n REL 2150 13000 min
0
REL 2450E 6000-13000 min
Air velocity 270 km/h
Suction rate 780 m
Volume of debris bag approx. 45 l
Sound volume level L 99,6 dB (A)
WA
Sound pressure level L 88 dB (A)
pA
Vibration a < 2,5 m/s
hv
5.0 Assembly
5.1. Mounting the vacuum tube
(Fig. 2a, 2b, 3a, 3b)
First plug together the front vacuum tube (1) and the
rear vacuum tube (2) as illustrated in Fig. 2a. Then
screw together with the special screws 4.2 x 18 mm
(see Fig. 2b).
Finally, plug the vacuum tube in the motor housing
(Fig. 3a) and fasten it in place with 4.2 x 12 mm
recessed head screws (Fig. 3b). The vacuum tube is
now secured in place.
Important: Please note that the two suction tubes
must always be joined together before they are
mounted on the motor housing, and that they
must never be taken apart when mounted!
Important: The garden blower vac is equipped
with a safety lock-off switch which only works
when the suction tube is mounted on the motor
housing.
5.2. Mounting the debris bag (Fig. 4)
Slip the debris bag (7) over the socket on the motor
housing. It engages correctly when it makes an
audible click. Then hang the two hooks on the
suction tube and the motor housing.
Seite 11
GB
-1
-1
3 /h
2
11