Zephyr Siena Pro Island Guide D'utilisation, D'entretien Et D'installation page 8

C
n .
m i
x . D
m a
Standard
Hood Heights Duct Cover
minimum (A) 32 "
1/2
maximum (B) 48 "
1/2
Ceiling Heights
minimum (C) 94 " (7' 10
1/2
maximum (D) 118
1/2
DUCTING
A minimum of 10" round duct is recommended to
maintain maximum air flow efficiency.
Always use rigid type metal ducts only. Flexible
ducts could restrict air flow by up to 50%.
Use calculation worksheet to compute total duct
work (Page 5).
ALWAYS, when possible, reduce the number of
transitions and turns. If a long duct run is required,
increase duct size from 10" to 12".
If turns or transitions are required: Install as far
away from duct opening and as far apart between
the two transitions as possible.
Minimum mount height between range top to hood
A
n .
bottom should be no less than 26".
m i
x . B
m a
Maximum mount height should be no higher than
34".
i n .
" m a x .
2 6
It is important to install the hood at the proper
" m
3 4
mounting height. Hoods mounted too low could
result in heat damage and fire hazard; while hoods
mounted too high will be hard to reach and will
loose performance and efficiency.
If available, also refer to range manufacturer's
"
height clearance requirements and recommended
3 6
hood mounting height above range. Always check
your local codes for any differences.
Duct cover extension kit available for ceiling
heights up to 12 feet. Turn to page 19 for part
Extension
number and ordering information.
Duct Cover
49"
81"
DAMAGE-SHIPMENT / INSTALLATION:
111" (9' 3")
1/2")
• Please fully inspect unit for damage before
" (9' 10 ") 151" (12' 7")
1/2
installation.
• If the unit is damaged in shipment, return the
unit to the store in which it was bought for
repair or replacement.
• If the unit is damaged by the customer, repair
or replacement is the responsibility of the
customer.
• If the unit is damaged by the installer (if other
than the customer), repair of replacement must
be made by arrangement between customer
and installer.
6
www.zephyronline.com