Cleaning And Maintenance - ohmex MIST FAN 4040 WTR Manuel D'utilisation

EN
• Select the misting function by pressing the MIST key on the appliance or remote control.
By pressing the on key, the MIST led switches on; by pressing it again the led switches
off (function deactivated).
The amount of water misted can be adjusted by rotating the regulator (20) clockwise
to increase it or anti-clockwise to decrease it.
• When there is no water in the container (18), the mister stops working and the green
led turns red.
In this case, disconnect the appliance electrically and restore the water in the container
to continue to use the appliance.
• It is possible to adjust the angle of inclination of misting by pushing downwards from
the upper part of the grid or pulling upwards from the lower part of the grid.
Before performing this operation, always switch the appliance off
and disconnect it from the electric power supply

CLEANING AND MAINTENANCE

• Always remove the plug from the mains socket before proceeding with any cleaning
operation.
• The motor has bearings which need no maintenance and/or lubrication.
• Use a damp cloth to clean the plastic parts.
• Use a brush to clean the grills.
• The water tank and the seat inside the main body must be cleaned periodically: the
water must be emptied after each use.
Wash the tank and the other parts with soapy water and rinse them with care, to avoid
the formation of dirt and lime scale.
• Avoid the use of abrasive products; do not use steel wool or abrasive products.
66
USE
FAN 4040 WTR