ohmex MIST FAN 4040 WTR Manuel D'utilisation page 65

FAN 4040 WTR
PREPARING THE APPLIANCE
d. Remove the screws from the main body.
Insert the main body onto the rods (10)
and then tighten the screws.
e. Position the mister supply base (21) on the base
of the fan (11).
f. Remove the nut (2) and lock-nut (4) from the
motor shaft pin.
g. Position the rear grid (5) centring it on the centring
pins.
h. Tighten the lock-nut (4) to block the rear grid (5).
The handle on the rear grid (5) must be facing
upwards.
i. Insert the fan (3) onto the motor shaft,
matching the grooves on the fan body
with the reference pin (X).
2
5
3
X
EN
10
4
4
61