Electromagnetic Fields (Emf); Preparing For Use - Philips BT7085 Mode D'emploi

- Children should be supervised to ensure that they do not play with
the appliance.
- Always check the appliance before you use it. Do not use the appliance
if it is damaged, as this may cause injury.
- Do not use the appliance in the bath or in the shower.
Caution
- Only use the adapter supplied.
- Use, charge and store the appliance at a temperature between 5°C
and 35°C.
- Do not charge the appliance in the storage pouch supplied (BT7085 only).
- Do not use the appliance if one of the trimming combs or the cutting
unit is damaged or broken, as this may cause injury.
- If the adapter, the cutting unit or one of the trimming combs is
damaged, always have it replaced with one of the original type in order
to avoid a hazard.
- This appliance is only intended for trimming the human beard. Do not
use it for any other purpose.
General
- The adapter is equipped with an automatic voltage selector and is
suitable for mains voltages ranging from 100 to 240 volts.
- The adapter transforms 220-240 volts to a safe low voltage of less than
24 volts.
- Noise level: Lc = 65 dB(A).

Electromagnetic fields (EMF)

- This Philips appliance complies with all applicable standards and
regulations regarding exposure to electromagnetic fields.

Preparing for use

Charging (BT7085/QT4070)
Charge the appliance fully before you use it for the first time and after a
long period of disuse.
Standard charging takes approximately 60 minutes.
1 Switch off the appliance before you charge it.
2 Insert the appliance plug into the appliance and put the adapter in
the wall socket.
When you start charging the empty appliance, the bottom segment
,
of the charge level indicator flashes orange. When the battery
contains enough power for one trimming session of approx.
7 minutes, the bottom segment starts flashing blue.
First the bottom segment of the charge level indicator flashes blue,
,
then the second segment and so on, until the appliance is fully
charged.
When the appliance is fully charged, all segments of the charge level
,
indicator light up blue continuously.
If the fully charged appliance is still connected to the mains after
,
1 hour, the segments of the charge level indicator go out.
ENGLISH
5