First Connection; Usb Charge - Scansonic M7 Guide D'instructions

OPERATION

First connection

1. Press "Power On/Off" to turn on the Scansonic M7 (Figure D).
2. Blue LED will indicate power on and the M7 will go into Bluetooth auto pairing.
3. Search Bluetooth on your phone/bluetooth device
4. Locate "M7" in the search list and connect.
Note: When using "Power On/Off" button for standby, the M7 will reconnect with latest
paired device, when powered on again If the M7 is switched off by disconnecting the
wall socket, it will start auto pairing when turned on again.
Disconnect/new pairing
1. Press " " to disconnect current phone/bluetooth device (Figure E).
2. The M7 is in auto pairing and ready to connect with a new device.
3. Search Bluetooth on your phone/bluetooth device
4. Locate "M7" in the search list and connect.
Line in/AUX
The Line in can be used to connect a phone/MP3 etc. without Bluetooth
1. Turn down the volume.
2. Connect a Mini Jack cable to the M7 (Figure F).
The sound from Bluetooth will be disconnected.
3. Connect a phone/MP3 etc. to the cable.
4. Start playing music from your device and adjust the volume.
Note: To reconnect the sound from Bluetooth, remove the cable from the M7.

USB Charge

This port is able to charge devices that support USB charge.
1. Press "Power On/Off" to turn on the Scansonic M7
2. Connect the USB cable supplied with your device (Figure G).
Note: If M7 is charging only, without any audio input, the unit will automatically enter
standby mode, after 3 hours.
When in standby mode, there is no USB charge function.
The USB Charge port is not able to transfer data or music, it's for charging only.
Figure D
Top View
Power On/Off
Figure E
Top View
Figure F
Back View
LINE IN
Figure G
USB charge
Top View
5