Battery Installation - Scansonic M7 Guide D'instructions

AC CONNECTION
Insert the small DC plug from the AC adaptor into the DC IN 18V jack (Figure A).
Connect the AC cord to the adaptor and connect the other end to a wall outlet
having 230V AC (Figure B).
Use only the AC adaptor supplied with this product.

BATTERY INSTALLATION

1. Eject the battery compartment (Figure C).
2. Install a CR2025 battery (Figure C).
3. Insert the battery compartment (Figure C).
4
Figure A
PRECAUTIONS
Follow these precautions when using a
battery in this device.
Warning: Danger of fire or explosion, if
Figure C
battery is incorrectly replaced.
Replace only with the same or
equivalent type.
Be sure to follow the correct polarity
when installing the batteries, as
indicated, in the battery compartment. A
reversed battery may cause damage to
the device.
If the device is not to be used for a long
period of time, remove the batteries to
prevent damage from possible battery
leakage.
Do not try to recharge a battery; it can
overheat and cause damage or injury.
Figure B
ADAPTOR
ADAPTOR