22 INSTALLATION
3
Lower the door into its final position and tighten
the screws located on both sides.
4
Push the drawer back until it clicks into place.
5
Replace the ice bin in the drawer. Insert the
Durabase basket in the rail assembly.
Connecting the Water Line
Before Beginning
This water line installation is not covered by the
refrigerator warranty. Follow these instructions
carefully to minimize the risk of expensive water
damage.
If necessary, call a qualified plumber to correct water
hammer before installing the water supply line to
the refrigerator. Water banging in the pipes, or water
hammer in residential plumbing can cause damage
to refrigerator parts and lead to water leakage or
flooding.
• Turn the icemaker OFF if the refrigerator will be
used before the water line is connected.
• Do not install the icemaker tubing in areas where
the ambient temperatures fall below freezing.
WARNING
• Connect to potable water supply only.
CAUTION
• To prevent burns and product damage, only
connect the refrigerator water line to a cold water
supply.
• Wear eye protection during installation to prevent
injury.
Water Pressure
You will need a cold water supply.
Water Pressure
models with
20–120 psi
water filter
(138 - 827 kPa)
where reverse
osmosis
40–60 psi minimum to reverse
water filtration
osmosis system (2.8 – 4.2 kgf/cm
system is
less than 2–3 seconds to fill a cup of
connected to
7 oz capacity)
a cold water
supply
,or
2