Voltage Measurements - Beha-Amprobe AC50A Mode D'emploi

1.800.544.2843
If the display is not visible during measurement, press the "HOLD"
button (3) to retain the display. The clamp can then be removed from
the conductor and the stored value read.

Voltage Measurements

�
D o not connect more than 600 V AC / DC to the input sockets. Exceeding
these values can endanger the operator, and may result in damage
to the instrument.
�
B efore switching to a new function, disconnect the probes from
the UUT.
�
O nly handle test leads and probes on the grips provided. Avoid tou-
ching the probes under any circumstances.
1) Turn selector switch (2) to 400K
2) Plug the black test lead into the "COM" socket and the red lead into
the "VΩ" terminal
3) Connect the probes to the UUT and read the display
If the display is not visible during measurement, press the "HOLD"
button (3) to retain the display. The probes can then be removed from
the conductor and the stored value read.
9
www.calcert.com
15
10 20
5 25
0 30
sales@calcert.com