Safety Instructions; Useful Tips - Pro-Ject Audio Systems Primary Mode D'emploi

Pro-Ject Primary
Dear music lover,
thank you for purchasing a Pro-Ject Audio Systems record player.
In order to achieve maximum performance and reliability with this record player you should study these instructions
for use carefully.
Warning
of a hazard for the
user,
the unit
or possible
misuse
Important notice
**
Your turntable has been delivered with a factory fitted and adjusted cartridge, please ignore the
cartridge set up instructions unless changing the cartridge at a later date.
During assembly and adjustment of the deck small parts could be lost if not carefully placed in a suitable
receptacle. Before starting assembly make yourself acquainted with the parts listed above and correspondingly
numbered in the technical drawings above. Separately packed items are marked with an asterisk
*.
Safety instructions
Avoid letting
liquids
enter the device
or
the
power supply. Never place
any
item containing liquid,
such
as
a
flower vase
on or near the device. Never
spill
any
liquid
on the device
or
the
power
supply.
Never
place
any naked flame
sources,
such
as
lighted candles on or near the device. The produd shall not
be used
in
damp
or wet
locations, next to a bathtub,
sink swimming pool
or any other
similar
conditions.
Keep plastic bags away from children to prevent any risk of suffocation.
Set-up
The deck is supplied partially disassembled and carefully packaged for safe transport. Carefully remove all
parts from the transport packaging.
Make sure the surface you wish to use the turntable on is level (use a spirit level) before placing the turntable on it.
Fit the drive belt (22) around the platter (3) and the smaller diameter part of the motor pulley (2). Avoid
getting sweat or grease on the belt as these will deteriorate the performance and reduce the belt's lifespan. Use
absorbent kitchen paper to remove any oil or grease from the outer edge of the platter and the belt.
Fit the felt mat over the spindle of the platter (3). Remove the transport lock (66) from the tonearm tube.
Store the transport lock in the original packaging so they are available for any future transportation .
Useful tips
The record player should be positioned on a low-resonance surface such as wood or multiple layer ply board
to avoid structural vibrations disturbing replay.
Cartridge downforce adjustment
The counterweight (4) supplied is suitable for cartridges weighing between 3,5 - 5,5g . The counterweight is
pre-set perfectly from the factory.
©
Pro-ject Audio Systems · Pro -Ject Primary
I
Pro 8.6UP
I
O rtofon OM SE · Revisio n 2015.4 .2 1
3