Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
LED Indication Function
The battery pack has a "SW" button and 4-step green LEDs for indicating remai-
ning capacity status and over temperature condition.
The remaining capacity (RC) and temperature protection status green LED indica-
tions ( 3 second ) when the "SW" button is momentarily pressed:
LED 1 (green)
LED 1, 2 (green)
LED 1, 2, 3 (green)
LED 1, 2, 3, 4 (green)
LED 1 Blinking (0.25sec./green)
LED 1 - 4 Blinking (0.5sec./green) Over temperature condition.
The LED Light on the Charger
•
Power On (Green light flashes slowly)
•
Battery Low (Red light stays illuminated)
•
Battery charged 80% (Green light flashes rapidly)
•
Battery charged 100% (Green light stays illuminated)
•
Battery pack temperature is too hot or too cold (Red light flashes slowly)
•
Battery Pack malfunction (Red and green lights stay illuminated).
WARNING! 1.
Charger is plugged into a 100-240V // 50-60 Hz. a.c outlet only.
2.
If the battery pack is too hot or too cold, the charger will not fast charge the battery
pack and the red Indicator light is "blinking". When the battery pack temperature
returns to between 0°C(32°F) and 50°C(122°F), the charger will automatically
begin charging.
If both red and green indicator lights are "ON" the battery pack either does not
3.
comply or is defective. Please contact your retailer.
4.
Remove the plug after finishing the charge.
5.
Do not use generator for charging the battery pack.
EN 17
0%- 25% remaining capacity
26%-50% remaining capacity
51%-75% remaining capacity
76%-100% remaining capacity
Battery is fully depleted
Publicité
Table des Matières
