Ribimex RIBILAND PRA/PB.1385 Manuel D'instructions Et D'utilisation page 10

The operator and/or user must use common sense and caution when operating the product especially
for any matters that are not referred in the above
3.3- Safety warnings regarding the use
1. Become familiar with the controls and the proper use of the product.
2. The use of this product by children is forbidden.
3. Only well-instructed adults should operate the product. This product is not intended for use by
persons (including children) with reduced physical, sensory or mental capabilities, or lack of
experience and knowledge, unless they have been given supervision or instruction concerning use of
the product by a person responsible for their safety.
IV- GETTING STARTED
Before any intervention on the product, remove the battery removed from its
compartment.
4.1- Unpacking
- Remove product from its packaging.
- Check that product and accessories are not damage
4.2- Inserting or replacing the battery
- Remove battery compartment / control box (8), by firmly pulling it.
- Insert a 9V alkaline battery type 6LR61 or 6F22 (not included) respecting the polarity.
- Replace the battery compartment / control box (8), by firmly inserting it on main body (9).
4.3- Assembly
1- Connect tap connector (1) (or the reducer (2)) to your water tap.
Firmly screw it by hand
Note: do not use any tool to avoid damaging the tap connector.
2- Screw the quick connector (7) to the thread on main body (9) lower part.
3- Connect the hose of your terminal to the quick connector (7).
Remarks:
- Install the timer vertically to avoid water dripping or entering into battery
compartment / control box (8).
- Do not force the quick connector (7) by for example pulling on the hose.
- Ensure that the metal filter (a) is properly fitted inside the tap connector (1). Do
not use the water timer without the metal filter (a).
Fig.2
Page 10 / 17