INVENTOR P3F-50L Manuel D'utilisateur page 14

3. Pump draining
While operating the dehumidifier with the pump
drainage setting, the drain hose outlet should be
shut be the supplied plug. The pump drainage hose
(od=1/4 supplied) can be placed at an elevated
level. Place the pump drainage hose into the
corresponding outlet of the unit and position the
drainage hose to a nearby drainage facility.
To activate the pump operation, press the pump
pad. When bucket is full the pump will start
operating.
• Upon activation of the pump, noise levels
may be higher for 3 to 5 minutes. This is
considered normal.
• Make sure hose connection is set firmly,
and no leaks are noticeable.
• Water hose should not be bent or tangled!
• Select the desired humidity setting and fan
speed level, for pump draining to initiate.
14
Note:
1) This operation should not be used when outdoor
temperatures are equal or less than 0oC (32 F), since water
within the hose will freeze and block the water flow,
possibly causing the unit to fail.
2) Bucket should be emptied once a week while in pump
draining operation. When this operation is not in use, the
pump drain hose should be removed from the outlet.
Pump
Drain Hose
Outlet
EN