Water Tank & Drain Hose - INVENTOR K1-10L Manuel D'utilisateur

7. WATER TANK & DRAIN HOSE
There are two ways to remove collected water. Before proceeding ensure that you have
switched off and unplugged the unit.
1. Usage of the water tank
When unit is OFF and the tank of the dehumidifier is full, the full bucket indicator will be
lit.
Additionally, when the unit is on and the tank is full, the compressor stops operation
followed by the fan a few minutes later, once again the full bucket indicator will be lit
• Slowly remove the bucket. Grip the handle with caution and carefully pull outwards so
the water does not overflow.
• Empty the water from the tank and place it again in to the device. The water tank, must
be securely and properly placed, for the dehumidifier to operate.
• When the water tank is re-installed the unit will automatically restart.
2. Continuous draining
Water automatically can be emptied into a floor
drain by attaching the unit with a water hose.
• Remove the rubber plug located opposite the unit.
Insert the water hose into the drain outlet and
make sure all connections are firmly tightened in
order to avoid any possible leaks.
• The dehumidifier should be placed on a flat
surface in an upright position.
• Lead the water hose towards a suitable drainage
facility and be certain that the water flows naturally.
For correct drainage, make sure the hose stays
below the level of the drain hose outlet.
EN
• When you remove the tank, do not touch any parts
inside the unit, as you may damage the device.
• Be sure to gently place the tank into the dehumidifier.
• Do not drink or use the collected water from the
device.
• Wipe any excess water on or in the unit when
removing the tank.
water
drain hose outlet
11