Auto Defrost - INVENTOR K3-10L Manuel D'utilisateur

• For drying clothes: place the dehumidifier in a small room and set nearby the
clothes rack. Keep doors shut and allow the dehumidifier to dry the clothes.
• For optimal results manual wringing of the clothes is suggested.
• Allow 30-50cm distance from the moist clothes.
• For special humidity conditions where big amounts of condensation need
to be extracted, such as extremely moist rooms.
• When immediate dehumidification is necessary such as in areas or rooms
not in use for an extended period of time, etc.
INDICATIONS
Bucket Full Indicator
Indicator "FULL" turns on following a beep alert when bucket is full, removed, or
misplaced.
• The water level control switch shuts off the dehumidifier when the bucket is
full, removed or misplaced.

Auto Defrost

When frost builds up on the evaporator coils, the compressor will cycle off and the fan
will continue to run until the frost disappears. In this case the indicator will turn on.
• The indicator light flashes at 0.5Hz under refrigerant leakage detection.
• The indicator light flashes at 5Hz under room temperature sensor error.
• The indicator light flashes at 5Hz under evaporator temperature sensor
error.
• This function not only ensures the safe and appropriate operation of the
dehumidifier but is also more efficient and economical in its performance.
10
Note:
• When Auto Defrost is operating, the unit
may cause some noise of the refrigerant fluids
flowing, this is normal.
• Do not turn the dehumidifier off when auto
defrost is operating.
• If the Αuto defrost indicator light flashes,
unplug the unit and plug it back in. If error
repeats, call for service.
EN