Altrad ELAG-025-T25 Manuel D'instructions Et D'utilisation page 37

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

5.2- Working with the chainsaw
WARNING
5.3- Guard against kickback
- This saw is equipped with a chain brake that will stop the chain in the event of kickback if operating
properly.
You must check the chain brake operation before each usage by running the saw at full the throttle for
1-2 seconds and pushing the front hand guard forward. The chain should stop immediately with the
engine at full speed. If the chain is slow to stop or does not stop, replace the brake band and clutch
drum before use.
- It is extremely important that the chain brake be checked for proper operation before each use and
that the chain be sharp in order to maintain the kickback safety level of this saw. Removal of the
safety devices, inadequate maintenance, or incorrect replacement of the bar or chain may increase the
risk of serious personal injury due to kickback.
- Before proceeding to your job, read the section "Safety".
It is recommended to first practice sawing easy logs. This also helps you get
accustomed to your machine.
- Always follow the safety regulations. The chain saw must only be used for
cutting wood.
It is forbidden to cut other types of material. Vibrations and kickback vary with
different materials and the requirements of the safety regulations would not be
respected. Do not use the chain saw as a lever for lifting, moving or splitting
objects. Do not lock it over fixed stands. It is forbidden to hitch tools or
applications to the PTO (driveshaft) other than those specified by the
manufacturer.
- It is not necessary to force the saw into the cut. Apply only light pressure
while running the engine at full throttle.
- When the saw chain is caught in the cut, do not attempt to pull it out by force,
but use a wedge or a lever to open the way.
- If the guide bar and saw chain becomes caught in wood while operating it,
stop the engine. Do not pry the handle with excessive force. Use a wedge to
remove the chain instead.
ATTENTION! National or local regulations may restrict the use of the
machine at certain times. Check with your local authority
Note: careful daily inspection should be performed before use and after a drop
or shock to identify major defects.
Do not use the machine until the defects have been repaired.
Restrict working hours to a minimum and always take rest periods.
For proper use, after each work period take a rest period (for ex take a rest for
10 minutes after a work period of 30 minutes).
37

Publicité

Table des Matières
loading

Table des Matières