Best WC33I Manuel D'instructions page 7

INSTALL THE DUCTWORK
DUCTED HOODS ONLY
CAUTION: To reduce the risk of fire,
use only metal ductwork.
1. Decide where the ductwork will run
between the hood and the outside.
Fig. 4.
2. A straight, short duct run will allow
the hood to perform most efficiently.
3. Long duct runs, elbows, and transi-
tions will reduce the performance of
the hood. Use as few of them as pos-
sible. Larger ducting may be required
for best performance with longer duct
runs.
4. Install a roof or wall cap. Connect
round metal ductwork to cap and
work back towards hood location. Use
duct tape to seal the joints between
ductwork sections.
INSTALL ELECTRICAL
DUCTED and NON-DUCTED HOODS
WARNING : Electrical wiring must
be done by a qualified person(s) in
accordance with all applicable codes
and standards. This range hood must
be properly grounded. Turn off electri-
cal power at service entrance before
wiring.
1. Plan where the hood will be located
above the cook top. Refer to the
"INSTALL MOUNTING BRACKET"
section for hood mounting height
options.
2. Install a standard 2" x 4" wall outlet
box and 3-blade 125 volt, 15 Amp
grounded receptacle. Fig. 5.
3. Mount the center of the wall outlet 5"
to 8" above the top of the hood.
4. Locate the box and the receptacle
within boundary shown and off center
of the ductwork (to allow for power
cord plug and flue clearance).
ROOF CAP
DECORATIVE
FLUE
HOOD

24" TO 30" ABOVE COOKING SURFACE
(see "INSTALL MOUNTING BRACKETS"
section for mounting restrictions)
3-3/8"
CENTERLINE
OF HOOD
- 7 -
6-INCH
ROUND DUCT
WALL
CAP
6-INCH
ROUND
ELBOW
FIG. 4
6-3/4"
5 - 8"
FIG. 5