S&P TLS-501 Notice D'utilisation page 11

.- Do not use the appliance in rooms whose area is less than 4m2.
.- Do not place the device where are air drafts, because can disrupt its proper
functioning.
.- On no account must any switch / button be accessible by people in the shower
or in the bath.
.- Whenever it is installed permanently, the convector must be situated so that
the plug is accessible.
.- Whenever you want use the device as a mobile heater mount the foot of it.
.- Always ensure that the air inlet and outlet grilles are clean.
.- This appliance is not intended for use by persons, including children, with
reduced physical, sensory or mental capabilities, or lack of experience and
knowledge, unless they have been given supervision or instruction concerning
use of the appliance by a person responsible for their safety.
.- Children must be under supervision at all times to avoid danger from potential
interference with the product.
.- This appliance must not be used connected to a programmer, timer or another
device that controls heater connection automatically.
.- Only for internal use
DESCRIPTION OF THE DEVICE (Figure 1)
1.- Power selector control.
2.- Thermostat control command.
3.- Light indicator- Device connected to the power supply.
4.- Support feet. (use as a mobile device).
5.- Fan support (Only TLS-503T model)
6.- Light switch fan support (only TLS-503T model)
INSTALLATION
Before starting the convector, the base must be fitted or the device must be
mounted on the wall.
FITTING THE BASE
Fit the base supports to the side (Fig. 5) and secure each one with four small
screws. (Fig.2).