M-Spa JetSpa M210A Mode D'emploi page 13

Spa Repair
If the Spa is torn or punctured use the provided Repair Patch. Dry the area to be repaired. Remove the patch
backing and place the patch over the damaged area. Smooth the surface to remove any air bubbles. A
secure unnoticeable repair can usually be made.
Spa Storage
Make sure all water is drained from the Spa and control box. This is essential to extend the life of the spa.
We recommend the use of a wet/dry vacuum to blow out or suck up water from the Spa pipes and Pump
lines. Remove the Filter Cartridge. It is recommended you store the spa in its original package in a warm
dry place.
NOTE: Plastic becomes brittle and susceptible to breakage when exposed to subzero temperatures.
Freezing can severely damage the Spa. Improper winterization of your Spa may void your warranty.
ORPC strives to provide the most trouble-free spas on the market. If you experience any problem whatsoever,
do not hesitate to contact us or our authorized dealer.
Here are some helpful tips to help you to diagnose and rectify some common sources of trouble.
Problems
Control box does not operate
Control box does not heat properly
Jet Massage System does not work
Water Filtration not working
Spa leakage
Water not clean
TROUBLESHOOTING
Probable Causes
-Power failure
-GFCI tripped
-GFCI broken
-Temperature set too low
-Dirty Filter Cartridge
-Improper water levels
-Heating element failed
-Pump is too hot
-2 hours auto shut off feature activated
-Something is wrong with the control
box
-Dirty Filter Cartridge
-Something is wrong with the control
box
-Spa is torn or punctured
-Insufficient filtering time
-Dirty Filter Cartridge
-Improper water maintenance
13
Solutions
-Check power source
-Reset GFCI/Check if the home fixed wiring too thin
to afford 2300W.
-Call for service if it does not reset.
-Set to a higher temperature (between 20-40 )
-Clean/replace the Filter Cartridge in time
--Add water to specified levels
-Call for service
-Unplug the Pump. After the Pump has cooled
insert the plug and press the bubble button to
activate
-Press the jet Button to reactivate
-Call for service if it does not reset
-Clean/replace the Filter Cartridge in time
-Call for service if it does not reset
-Use provided Repair Patch
-Increase filtration time
-Clean/replace the Filter Cartridge
-Refer to the chemical manufacturer's instructions