Changing The Alarm Snooze Time; Appendix; Installing The Chargepak B1 - PURE Evoke D1 EN Mode D'emploi

Changing the alarm snooze time

1. Press the Menu button and press the Select dial to choose 'CLOCK'.
2. Turn and press the Select dial to choose 'SNOOZE'.
3. Turn and press the Select dial to choose a snooze time between 5 and 59 minutes.
Clock synchronization options
You can select the radio sources that you want to use for setting the time. By default, Evoke uses both the FM and digital
radio signals to synchronize the time.
To specify the synchronization options:
1. Press the Menu button and turn and press the Select dial to choose 'CLOCK'.
2. Turn and press the Select dial to choose 'SYNC TO'.
3. Turn and press the Select dial to choose the required clock synchronization option.

Appendix

Installing the ChargePAK B1

5.5V DC
1. Switch Evoke off and disconnect from the mains
power supply.
2. Open the battery compartment.
3. Insert the ChargePAK connector plug into the socket
in the compartment. Line up the ridges on the
plug with the slots in the socket to ensure correct
orientation. Do not force the plug.
4. Insert ChargePAK into the battery compartment, logo
side out.
5. Replace the battery cover and connect Evoke to the
mains.
6. ChargePAK will begin charging.
Note: If you are charging ChargePAK for the first
time or after an extended period of inactivity it is
recommended that it is charged for around 24 hours
to ensure full battery power. If ChargePAK is flat there
may be a slight delay before the battery charging
indicator is displayed.
EN
13