Digital Radio Settings; Fm Settings; Audio Settings; Display Settings - PURE Evoke D1 EN Mode D'emploi

Digital radio settings

Autotune
You can use the autotune function to automatically scan for new digital radio stations and remove inactive ones.
Note: Autotune is only available when you have selected 'Digital' as the radio source.
To carry out an autotune:
1. Press the Menu button.
2. Turn and press the Select dial to choose 'AUTOTUNE'. The number of stations found will be displayed during the autotune.
When the autotune has finished, Evoke will tune to the last station that you were listening to.

FM settings

FM stereo option
You can choose between 'STEREO' or 'MONO' reception when listening to FM radio. You may want to choose 'STEREO' if
listening using headphones.
Note: The FM stereo option is only available when you have selected 'FM' as the radio source.
To change between stereo or mono reception:
1. Press the Menu button.
2. Turn and press the Select dial to choose 'FM STEREO'.
3. Turn and press the Select dial to choose between 'STEREO' or 'MONO' FM reception.
FM tuning mode
Press the Menu button and turn and press the Select dial to choose 'TUNE'. Choose from the following two modes:
SEEK: When you turn the Select dial, the radio tunes to the next station with a good signal.
MANUAL: When you turn the Select dial, the radio tunes up or down the FM radio frequency range by 0.05 MHz.

Audio settings

To adjust the bass and treble settings:
1. Press the Menu button.
2. Turn and press the Select dial to choose 'AUDIO'.
3. Turn and press the Select dial to choose 'BASS' or 'TREBLE'.
4. Turn and press the Select dial to set the level from '-6' (low) to '+6' (high).

Display settings

Changing the backlight brightness level
1. Press the Menu button and turn and press the Select dial to choose 'DISPLAY'.
2. Turn and press the Select dial to choose 'BACKLIGHT'.
3. Turn and press the Select dial to adjust the brightness level when Evoke's display is 'ACTIVE' or in 'STANDBY'.
4. Turn and press the Select dial to select 'LEVEL'.
5. Turn and press the Select dial to set a brightness level between '1' (dim) and '5' (bright).
EN
11