Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
D
n .
m i
E
n .
m i
x . F
m a
Standard
Hood Heights
Duct Cover
minimum ducted (A) 32"
minimum recirculating (B) 36
1/2
maximum (C) 50"
Ceiling Heights
minimum ducted (D) 94" (7' 10")
minimum recirculating (E)
98
1/2
maximum (F) 120" (10')
DUCTING
A minimum of 8" round duct is recommended to
Always use rigid type metal ducts only. Flexible
ALWAYS, when possible, reduce the number of
transitions and turns. If a long duct run is required,
increase duct size from 8" to 10".
If turns or transitions are required: Install as far
away from duct opening and as far apart between
the two transitions as possible.
Minimum mount height between range top to hood
A
n .
m i
bottom should be no less than 26".
B
n .
m i
x . C
m a
Maximum mount height should be no higher than
34".
i n .
" m
a x .
2 6
It is important to install the hood at the proper
" m
3 4
mounting height. Hoods mounted too low could
mounted too high will be hard to reach and will
If available, also refer to range manufacturer's
"
height clearance requirements and recommended
3 6
heights up to 12 feet. Turn to page 21 for part
Extension
number and ordering information.
Duct
Cover
49"
"
53
"
1/2
80"
DAMAGE-SHIPMENT / INSTALLATION:
• Please fully inspect unit for damage before
111" (9' 3")
installation.
" (8'2
") 115
" (9'7
")
1/2
1/2
1/2
150" (12' 6")
• If the unit is damaged in shipment, return the
unit to the store in which it was bought for
repair or replacement.
• If the unit is damaged by the customer, repair
or replacement is the responsibility of the
customer.
be made by arrangement between customer
and installer.
6
www.zephyronline.com
Publicité
Table des Matières
