Mounting Of The Resin Cartridges - W&H Dem 32 Manuel D'utilisation

MOUNTING OF THE RESIN CARTRIDGES

1
IN
2
1. Remove the filter head cover.
2. Remove the tubes from the two quick connectors (IN/OUT) on the unit head and lift the entire
cartridge assembly from the demineralizer base.
3. Unscrew the two resin cartridge holders (by hand or with the use of the special key).
4. Remove the cartridges' bag and place them into the holders (with the cone-shaped side facing
downwards and the word "UP" at the top).
5. Place the o-rings in the groove of the resin cartridge holders and tighten holders by hand (use
only moderate force if you use the special key).
6. Place the cartridge assembly back into the demineralizer base and fix it into place with the use
of the positioning rings.
7. Reconnect the tubes to the IN and OUT connectors (make sure that the IN connector is on the
left hand side).
8. Attach the filter head cover.
Dem 32
OUT
2
4
5
2
4
5
7
9