Getting Started; Operation; Switching The Line Laser On And Off; Aligning The Line Laser - Powerfix Profi PLBS 2 A1 Traduction Des Instructions D'origine

Getting started

■ After inserting the batteries, the appliance is
ready for use.
■ Remove the protective cover/wall bracket
from the appliance.
■ Fully grip the appliance with one or, ideally,
both hands. The appliance is suitable for either
hand.

Operation

CAUTION!
► Use the appliance only for its intended use.
► Check the appliance for damage before use.
Do not use the appliance if its operational
safety cannot be guaranteed.
Switching the line laser on and off
♦ To switch the line laser
ON/OFF switch .
■ To make the levels
are illuminated.
♦ Switch the laser off again by pressing the
ON/OFF switch .

Aligning the line laser

♦ Align the appliance using the horizontal
vertical levels by changing the tilt angle of
the appliance. Centre the air bubble in one of
the levels between the two marking lines.
♦ For diagonal alignment of the laser, mark two
points in the desired alignment and line up the
laser with these markings.
♦ Switch on the vacuum pump (see section
Appliance suction function).
│ GB │ IE │ NI
■ 6
on and off, press the
easier to read, these
and
♦ To use the line laser
tion, you can release it from the mount by pulling
it in a horizontal direction.
♦ Replace the line laser on the guide and push it
in the direction of the battery compartment
until it clicks audibly into place.

Using the drill dust collector

♦ Mark the spot on the wall where you want to
drill the holes.
♦ Push the loaded drill through the opening on
the protective plate
other side of the seal
♦ Put the tip of the drill bit onto the marking.
♦ Hold the drill vertically to the wall.
♦ Push the drill dust collector
wall so that the seals
wall.
NOTE
► To ensure that the drill dust collector
the dusts optimally, it should always be
aligned vertically.
♦ Switch on the vacuum pump (see section
Appliance suction function).
♦ Hold the drill firmly in both hands and follow the
manufacturer's operating and safety instructions.
♦ Use only suitable drills up to a max. 10 mm in
diameter.
♦ Wear your personal protective equipment
(safety goggles)!
♦ Pull the drill out of the drill dust collector
before you switch off the vacuum pump.

Emptying the drill dust collector

♦ Point the drill dust collector
Press the release buttons
sides between your thumb and index finger and
swing the cover of the drill dust collector
upwards.
♦ Empty the drill dust collector
without the suction func-
until it comes out of the
.
up against the
lie up against the
collects
downwards.
together on both
.
PLBS 2 A1