Appliance-Specific Safety Instructions; Before Use; Inserting/Replacing The Batteries; Using The Protective Cover/Wall Bracket - Powerfix Profi PLBS 2 A1 Traduction Des Instructions D'origine

■ Do not open, dismantle, pierce, modify or throw
batteries and avoid unnecessary impacts.
■ Do not expose batteries to naked flames or
temperatures of above 50°C. Do not store bat-
teries in hot locations and do not expose them
to direct sunlight.
■ Never immerse batteries in water or other liq-
uids.
■ Never place batteries in a microwave or high-
or low-pressure container.
■ Improper use may cause fluid to leak out of the
battery. If this happens, avoid contact with the
fluid. If contact occurs, flush the affected area
with water. Seek additional medical help if any
of the fluid gets into your eyes. Leaking battery
fluid can cause skin irritations or burns.
■ Incorrect use can cause vapours to escape that
can cause damage to health and respiratory
irritation. Ventilate the area immediately with
fresh air and obtain medical advice.
■ Incorrect handling can lead to a short-circuit or
an explosion!
■ Dispose of used batteries and defective appli-
ances in compliance with legal requirements.
Appliance-specific safety instructions
■ Keep the appliance away from wet or dampness.
Water getting into the appliance may lead to
an electric shock.
■ Do not work with this appliance in water or
other liquids.
■ Keep firm hold of the appliance and do not
drop it.
■ Avoid unintended switching on. Check that the
appliance is switched off when you insert a bat-
tery. Inserting batteries into the appliance while
it is switched on can cause accidents.
■ Do not block off the openings on the appliance.
PLBS 2 A1

Before use

Inserting/replacing the batteries

Vacuum pump
♦ To insert batteries, open the battery compart-
ment by turning the cover anticlockwise and
removing it.
♦ Insert the supplied batteries or two equivalent
AA batteries. Observe correct polarity when
inserting batteries to avoid damage!
♦ Replace the cover and close it by turning it in
a clockwise direction until it clicks firmly into
place.
Line laser
♦ To insert the batteries, first remove the appli-
ance from the protective cover
♦ Open the battery compartment cover
underside of the line laser and remove it.
♦ Insert the supplied button cells or three equiva-
lent type LR44 button cells. Observe correct
polarity when inserting batteries to avoid dam-
age.
♦ Replace the battery compartment cover
close it so that it clicks firmly into place.
Using the protective cover/wall
bracket
The protective cover
protect the soft seals
appliance is not in use.
♦ After use, always replace the protective cover
♦ You can attach the protective cover
determined attachment point on the wall with a
screw and use it as a wall bracket.
.
on the
and
is intended primarily to
from damage when the
to a pre-
GB │ IE │ NI │
5
.
■