Appliance Suction Function; Detaching The Appliance; Troubleshooting - Powerfix Profi PLBS 2 A1 Traduction Des Instructions D'origine

♦ Place the outer tab of the cover
centring rib of the cover.
♦ Swing the cover back until the release buttons
click audibly into place on both sides.
♦ Ensure that the cover is firmly in place on the
drill dust collector. This is the only way to pre-
vent dust escaping.

Appliance suction function

♦ After you have aligned the laser or put the drill
dust collector/drill against the wall, switch on
the vacuum pump at the switch
♦ Push the appliance briefly firmly against the
wall. After a short time, the appliance will be
firmly sucked against the wall.
♦ Ensure that the seal
against the wall.
♦ Check that the appliance stays in place by
trying gently to pull it off or slide it across the
surface.
♦ Leave the vacuum pump switched on the whole
time you are working with the line laser and/or
the drill dust collector. Otherwise, the appliance
will not be able to maintain a sufficient vacuum
and the appliance could come off the wall.
♦ Do not use the appliance for overhead work.
♦ If the appliance does not remain on the wall,
it may be because the surface structure of the
wall is simply too rough, and the appliance is
unable to generate a sufficient vacuum. In this
case, you will need a second person to hold the
appliance in place.
♦ Ensure that the seal
by rough surfaces, edges or corners.
PLBS 2 A1
back on the
.
of the appliance is fully
is not damaged or cut

Detaching the appliance

♦ First, finish your work with the line laser and/
or the drill and then remove the drill from the
appliance.
♦ Hold the appliance firmly in place to prevent it
from falling down.
♦ Switch off the vacuum pump at the switch
and press the vacuum button
♦ Remove the appliance from the surface.
♦ Use the protective cover
ance and the seals

Troubleshooting

–
The laser is not working
Battery is dead > replace battery.
–
Appliance does not grip onto the surface
Battery is dead or too weak > replace battery.
Seal is damaged > Hold the appliance by
hand.
Wall structure is too rough > Hold the appli-
ance by hand.
.
to protect the appli-
.
GB │ IE │ NI │
7 ■