PROG.: Your appliance is equipped with a
function permitting operation that ensure
automatic starting and stopping.
The programming steps for «PROG» are as
follows:
1. Long press the «PROG» button to start
the programming, you can see the time
and «PROG» message flash.
2. Press the «+» or «–» buttons to set the
start time you desire.
3. Long press the timer button to set stop
time, you can see the time message
flash.
4. Press the «+» or «–» buttons to set the
stop time you desire.
5. Validating the stop time by pressing
«TIMER» button again.
6. You can set the above mentioned ope-
ration mode and oscillation function by
pressing «MODE» button and «OSC»
button if you would like.
7. Validating the start time and program-
ming chosen by pressing «PROG»
button, then the fan of the appliance
and oscillation function (if chosen) will
stop after 30 seconds, the «PROG»
function is now active, all the sets will
show (except «OSC» function)in the
display, the appliance will start and stop
automatically according to the program-
ming you have selected
NOTE: You cannot change the sets after
step no. 7 unless long press «PROG»
button.
When the PROG function is active you can
carry out the following operations:
E
• Adding or modifying program-
med function: Use the same method
as for the 1 st programming (Starting the
programming step no. 1 above).
• Cancelling the start time and stop
time: Short press the
the start time and stop time will be
cancelled, the appliance is again in
manual mode.
18
• Cancelling all the programmed
operations at once: Press the power
switch knob for more than 1 minute.
How to clean the filter
The filters need regular cleaning
(once 1 week), following the steps below :
1. Unscrew the 1 screws which fix the
filters on the back of the heater.
2. Remove the filter according to the
arrow direction, and clean them.
3. After cleaning, follow the above
instructions in reverse order to assemble
the filters.
CAUTION:
Do not assemble the filter before
it is dry. Do not use the appliance
without its filter.
button,
Screws