Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
pressed, press the
display panel gets dark immediately , the
fan of the appliance and oscillation function
(if active) will stop after 30 seconds.
Mode:
Press the «MODE» button to select your
operating mode.
����
On the control panel:
The operating mode indicator lights up.
«AUTO» mode:
set the temperature to between 7°C and
35°C using the «+» and «–» buttons;
this temperature depends on your idea of
comfort. It is automatically validated after a
few seconds.
You can see on the panel:
After a few seconds «SELECT» disappears,
you can then read the temperature of the
room in the «HOUSE» icon.
To display your temperature setting, simply
press «+» «–» buttons.
Note: if the temperature you have set is
lower than that of the room (measured at
the appliance) then the appliance stops
automatically. The icon underneath the
«AUTO» message on the display panel then
flashes. The appliance starts heating again
as soon as the temperature of the room
drops below the temperature set.
mode:
the appliance operates in cold air. You
cannot set the temperature in this operating
mode.
«ECO» mode:
the appliance operates at a power setting
of 1000W and automatically sets the tem-
perature to 19°C, if the room temperature
(measured at the appliance) is higher than
once again, the
���
����
that of the default then the appliance stops
automatically and the «ECO» icon flashes.
You cannot set the temperature in this
operating mode.
You can see on the panel: the temperature
of the room in the «HOUSE» icon.
«HIGH» mode:
the appliance operates at a power setting
of 1800 unregulated.
You cannot set the temperature in this
operating mode.
You can see on the panel: the temperature
of the room in the «HOUSE» icon.
«OSC»
:
Press the button to make the appliance
oscillate in horizontal direction. Press again
to stop oscillating, a beep will be emitted by
the appliance each time. You can see on the
panel: No icon on the oscillation function.
«+» and «–» buttons: 2 buttons for setting
the mode temperature and for setting the
«TIMER» and «PROG» functions.
«TIMER»
:
Long press the button, you can see the
hours of the clock flashing, press the «+»
or «–» buttons to set the hours you desire,
then validate by pressing the «TIMER»
button or after 7 seconds automatically.
��������
���
���
���
����������
���� ����
����
��������
����� ���
�������
����� ���
E
17
Publicité
Table des Matières
