Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Dear Customer
Congratulations on your purchase of this
SOLIS fan heater, type 704.
To get the most out of your fan heater in
complete safety, please read through these
instructions carefully before using it for the
first time. They contain important tips for
the use, safety and maintenance of this
appliance. Please keep these operating
instructions somewhere safe.
Please do not allow persons who are
not familiar with these operating in-
structions to use your fan heater. We
hope you will be completely satis-
fied with your new SOLIS appliance.
IMPORTANT
– Before operating the heater, please
read these instructions thoroughly to
avoid damage and hazardous situations.
– Connect the heater to a 230V, 10A
socket.
– Never turn the heater on if the lead
E
is damaged, if the heater's casing is
obviously damaged or was damaged
subsequent to being dropped.
– The fan heater is excellent to provide
additional heating: it should not be
considered as a centralized central
heating unit.
– Make sure that the heater never comes
into contact with water.
– Do not let children play with the heater.
Do not poke anything through the
ventilating slits.
16
– Always use the heater in the horizontal
position; stand it on a firm, solid,
horizontal base (not on thick pile
carpets).
Leave plenty of room around the heater
(at least 50cm on top and round the
sides, 120cm at the front).
– Leave nothing hanging above or in front
of the heater (e.g. clothes or fabrics). Be
sure that the air inlets and outlets on the
heater are unhindered otherwise it will
overheat. Dust these openings every now
and again.
– Do never position the appliance under an
outlet.
– For substitution of the cable please refer
to service centers only.
– WARNING: Never install or use the
appliance close to bath tubs, showers,
wash basins, swimming pools.
If the appliance is installed in a bath-
room, always comply with safety
distances as indicated by CEI-CEE
regulations (see page 19).
OPERATION
INSTRUCTION
• Power selection
1. Before use the appliance place it on
stable flat surface.
2. Insert the plug into the power socket.
3. Switch on the appliance with the main
switch. Note: a beep will be emitted by
the appliance.
Press the button
starts, the display panel lights up, note: a
beep will be emitted by the appliance each
time that the control buttons are used or
, your appliance
Publicité
Table des Matières
